Lexus NX: Rear Door Outside Moulding
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 OUTSIDE MOULDING RETAINER *2 REAR DOOR LOWER OUTSIDE MOULDING SUB-ASSEMBLY LH *3 REAR DOOR NO. 2 WEATHERSTRIP LH *4 REAR DOOR REAR UPPER OUTSIDE MOULDING
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedures listed below are for the LH side.
PROCEDURE 1. REMOVE REAR DOOR LOWER OUTSIDE MOULDING SUB-
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE REAR DOOR UPPER OUTSIDE MOULDING PA
SEE MORE:
Sliding Roof ECU Communication Stop (B1273)
DESCRIPTION This DTC is stored when LIN communication between the sliding roof drive gear sub-assembly and main body ECU (multiplex network body ECU) stops for 10 seconds or more. DTC No. Detection Item DTC Detection Condition Trouble Area B1273 Sliding Roof ECU Communication Stop N
ACC Signal Circuit
DESCRIPTION This circuit detects whether the power switch is on (ACC) or off, and sends this information to the main body ECU (multiplex network body ECU). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE:
Inspect the fuses for circuits related to this system before performing the following procedu
© 2016-2026 Copyright www.lexunx.com
