Lexus NX: Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR SIDE SPOILER SUB-ASSEMBLY LH
(a) Attach the 2 clips and guide to install the rear side spoiler sub-assembly LH.
2. INSTALL REAR SIDE SPOILER SUB-ASSEMBLY RH
HINT:
Use the same procedure described for the LH side.
3. INSTALL REAR SPOILER ASSEMBLY
(a) Attach the 7 clips to install the rear spoiler assembly.
(b) Connect the 2 connector.
(c) Install the 2 bolts.
Torque:
6.6 N·m {67 kgf·cm, 58 in·lbf}
(d) Install the 4 nuts.
Torque:
6.6 N·m {67 kgf·cm, 58 in·lbf}
(e) Install the 2 hole plugs.
4. INSTALL BACK DOOR CENTER GARNISH
Click here .gif)
READ NEXT:
Rear Wheel House Plate
ComponentsCOMPONENTS ILLUSTRATION *1 REAR WHEEL FRONT HOUSE PLATE LH - - RemovalREMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure
Components
COMPONENTS ILLUSTRATION *A w/ Roof Rack - - *1 REAR ROOF DRIP SIDE FINISH MOULDING LH *2 ROOF DRIP SIDE FINISH MOULDING CLIP *3 ROOF DRIP SIDE FINISH MOULDING LH - -
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE:
Do not replace the spiral cable with the battery connected and the power switch on (IG).
Do not rotate the spiral cable when the following conditions are met: 1) The steering wheel is removed, 2) the battery is connected, and 3) thepower switch on (IG).
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Meter / Gauge System DTC No. Detection Item Link B1321 Lost Communication with EMV B1326 Lost Communication with Clock Device (Local-CAN) B1500 Fuel Sender Open Detected B1507 Open in Turn Signal Circuit B1508 Sho
© 2016-2026 Copyright www.lexunx.com
