Lexus NX: Personal Light

READ NEXT:

 Components

COMPONENTS ILLUSTRATION *1 MAP LIGHT ASSEMBLY (PERSONAL LIGHT) *2 MAP LIGHT SUB-ASSEMBLY

 Removal

REMOVAL PROCEDURE 1. REMOVE MAP LIGHT ASSEMBLY (PERSONAL LIGHT) (a) Using moulding remover D, detach the 4 clips. (b) Disconnect the connectors and remove the map light assembly (person

 Disassembly

DISASSEMBLY PROCEDURE 1. REMOVE MAP LIGHT SUB-ASSEMBLY (a) Using a screwdriver, detach the 17 claws and remove the map light sub-assembly. HINT: Tape the screwdriver tip before use. *1

SEE MORE:

 Pointer not Displayed on Screen or Pointer does not Move

CAUTION / NOTICE / HINT NOTICE: When replacing the radio receiver assembly, always replace it with a new one. If a radio receiver assembly which was installed to another vehicle is used, the following may occur: A communication malfunction DTC may be stored. The radio receiver assembly may not

 Drive Motor "B" Position Sensor Circuit Range / Performance (P0A46-126)

DTC SUMMARY MALFUNCTION DESCRIPTION This DTC indicates that an overvoltage in the inverter has occurred. The cause of this malfunction may be one of the following: Internal inverter malfunction Inverter internal circuit malfunction Rear traction motor with transaxle assembly malfunction Ope

© 2016-2026 Copyright www.lexunx.com