Lexus NX: Reassembly

Lexus NX Service Manual / Vehicle Exterior / Exterior Panels / Trim / Rear Spoiler / Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL PACKING

(a) Install 3 new packings.

2. INSTALL REAR SPOILER NO. 2 PROTECTOR

HINT:

When installing the rear spoiler No. 2 protector, heat the rear spoiler assembly using a heat light.

Standard:

Item	Temperature
Rear Spoiler Assembly	20 to 30°C (68 to 86°F)

NOTICE:

Do not heat the rear spoiler assembly excessively.

(a) Clean the rear spoiler assembly surface.

(1) Using a heat light, heat the rear spoiler assembly surface.

(2) Remove the double-sided tape from the rear spoiler assembly.

(3) Wipe off any tape adhesive residue with cleaner.

(b) Install 2 new rear spoiler No. 2 protectors.

(1) Using a heat light, heat the rear spoiler assembly.

(2) Remove the peeling paper from the face of the rear spoiler No. 2 protector.

HINT:

After removing the peeling paper, keep the exposed adhesive free from foreign matter.

(3) Install the 2 rear spoiler No. 2 protectors as shown in the illustration.

HINT:

Press the rear spoiler No. 2 protector firmly to install it.

3. INSTALL CENTER STOP LIGHT ASSEMBLY

Click here

SEE MORE:

Reassembly

REASSEMBLY CAUTION / NOTICE / HINT HINT: A bolt without a torque specification is shown in the standard bolt chart. Click here PROCEDURE 1. INSTALL CUSHION (a) Install the cushion. HINT: Use the same procedure as for the LH side. 2. INSTALL BACK DOOR LOWER STOPPER LH (a) When replacing the b

Short in GPS Antenna (B15C0,B15C1)

DESCRIPTION These DTCs are stored when a malfunction occurs in the navigation antenna assembly. DTC No. Detection Item DTC Detection Condition Trouble Area B15C0 Short in GPS Antenna Navigation antenna error Navigation antenna assembly Antenna cord sub-assembly Navigation E

Lexus NX: Reassembly

READ NEXT:

Installation

Rear Wheel House Plate

Roof Drip Side Finish Moulding

SEE MORE:

Reassembly

Short in GPS Antenna (B15C0,B15C1)