Lexus NX: Power Steering System (for Manual Tilt And Manual Telescopic Steering Column)
Lexus NX Service Manual / Steering / Power Assist Systems / Power Steering System (for Manual Tilt And Manual Telescopic Steering Column)
- Precaution
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Freeze Frame Data
- Fail-safe Chart
- Data List / Active Test
- Diagnostic Trouble Code Chart
- On-vehicle Inspection
- Torque Sensor1 (C1511-C1514)
- Short in Motor Circuit (C1521,C1531-C1534)
- Motor Terminal Voltage (C1524,C1555)
- Motor Rotation Angle Sensor (C1528)
- Vehicle Speed Signal (C1541)
- IG Power Supply Voltage (C1551)
- PIG Power Supply Voltage (C1552,C1554)
- Error in Matching of ECUs (C1567)
- Assist Map Number Un-Writing (C1581)
- Assist Map Number Mismatch (C1582)
- Lost Communication with Brake System Control Module (U0129,U0293,U1104)
- Power Steering Warning Light Circuit
READ NEXT:
Precaution
PRECAUTION HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM (a) This vehicle is equipped with a Supplemental Restraint System (SRS). Failure to carry out service operations in the correct sequence could cau
Parts Location
PARTS LOCATION ILLUSTRATION *1 POWER STEERING ECU ASSEMBLY *2 ELECTRIC POWER STEERING COLUMN SUB-ASSEMBLY - POWER STEERING MOTOR ASSEMBLY - MOTOR ROTATION ANGLE SENSOR - TORQUE SENSOR - ECU
System Diagram
SYSTEM DIAGRAM
SEE MORE:
Stroke Sensor (C1247,C1346,C1392)
DESCRIPTION The brake pedal stroke sensor assembly sends a signal about the pedal stroke to the skid control ECU (brake booster with master cylinder assembly). DTC C1346 will be cleared when the brake pedal stroke sensor assembly sends a brake pedal stroke sensor assembly signal or when Test Mode en
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT BUMPER ASSEMBLY Click here 2. REMOVE NO. 3 ENGINE ROOM WIRE Click here 3. REMOVE CLEARANCE LIGHT ASSEMBLY LH Click here 4. REMOVE CLEARANCE LIGHT ASSEMBLY RH HINT: Use the same procedure described for the LH side. 5. REMOVE HOOD TO FRONT END PANEL SEAL Click h
© 2016-2026 Copyright www.lexunx.com
