Lexus NX: Wheel Opening Moulding(for Rear)
Lexus NX Service Manual / Vehicle Exterior / Exterior Panels / Trim / Wheel Opening Moulding(for Rear)
READ NEXT:
Components
COMPONENTS ILLUSTRATION *1 QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH - - ILLUSTRATION *1 NO. 5 MOULDING TAPE *2 REAR LOWER QUARTER MOULDING PROTECTOR LH ● Non-reusable pa
Removal
REMOVAL CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE QUARTER OUTSIDE MOULDING SUB-ASSEMBLY L
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. REMOVE NO. 5 MOULDING TAPE (a) Remove the
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT FRONT DOOR LOCK ASSEMBLY LH (a) Check the door lock motor operation. (1) Apply auxiliary battery voltage to the motor connector and check the operation of the door lock motor. OK: Measurement Condition Specified Condition Auxiliary battery positive (+)
Precaution
PRECAUTION FOR OPERATION OF ELECTRICAL ITEMS RESTRICTED NOTICE:
If the auxiliary battery voltage is low, the seat heater system may not operate. When "High Power Consumption / Partial Limit On AC/Heater Operation" is displayed on the multi-information display in the combination meter assembly, in
© 2016-2026 Copyright www.lexunx.com
