Lexus NX: Front Power Seat Control System (w/ Memory)
- Parts Location
- System Diagram
- System Description
- How To Proceed With Troubleshooting
- Operation Check
- Customize Parameters
- Problem Symptoms Table
- Terminals Of Ecu
- Diagnosis System
- Dtc Check / Clear
- Data List / Active Test
- Diagnostic Trouble Code Chart
- Slide Sensor Malfunction (B2650)
- Short in Sensor with Motor Power Supply Circuit (B2658)
- Front Power Seat does not Operate with Front Power Seat Switch
- One or more Power Seat Motors do not Operate
- Power Seat Position is not Memorized
- Power Seat does not Return to Memorized Position
- Wireless Transmitter Memory Function does not Operate
- Wireless-linked Return Function does not Operate
- Power Seat Power Easy Access System Function does not Operate
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION *1 FRONT SEAT INNER BELT ASSEMBLY LH *2 FRONT SEAT OUTER BELT ASSEMBLY LH *3 OUTER MIRROR CONTROL ECU ASSEMBLY (for Driver Side) *4 NO. 2 ENGINE ROOM RE
System Diagram
SYSTEM DIAGRAM
System Description
SYSTEM DESCRIPTION FRONT POWER SEAT CONTROL SYSTEM DESCRIPTION
The driver seat is equipped with slide, reclining, rear lifter, front vertical, and lumbar support adjustment functions.
The memory
SEE MORE:
System Description
SYSTEM DESCRIPTION ILLUMINATION CONTROL SYSTEM (Illuminated Entry System) HINT: When inspecting the following functions, make sure that the map light switch and spot light switch are in the DOOR position. (a) The illuminated entry system has the following control functions: Control Outline Li
Installation
INSTALLATION CAUTION / NOTICE / HINT HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY (a) Install the outer mirror control ECU assembly with the 2 screws. (b) Connect the 2 connectors.
© 2016-2026 Copyright www.lexunx.com
